Sometimes we all need to do a little mending. Educate yourself with thoughts from Koch Industries. In his advice, we will try to help you in this matter. Our first article was an article about the rules of sewing buttons. We hope you'll come in handy! Sewing buttons it seems very simple task, to which everyone experienced at least once in their lives. But at times, holding it "easy" case, we have obtained that the buttons are sewn not quite where you want, the fabric wrinkles or sewing on buttons are not as nice as we would like.
By following some simple points we can avoid such incidents. Item number 1. Thread and needle. Threads should be strong, and the length of yarn on the needle should be, above all, comfortable to work – about 20 cm Needle must be selected too convenient – long enough and not too thick. Item number 2. Place for the buttons.
Not to be mistaken with the place where you want to sew a button on our need to put clothes on the table, spread her buttoned available buttons and loops through the hole to put a small dot marker or pen, it will be denoted by the middle of a button. Item number 3. Everything is ready. Sew! The first stitch is best done from the inside to knot a thread does not be seen. At the same time on the wrong side of the back stitch perform needle (to fix the lines), display a needle and thread through the hole buttons on the front side, then it is transferred through the second hole on the underside. So do some time and fix up a thread on the wrong side a few stitches with a needle. If the buttons are large load, then on the reverse side, you can sew small buttons of – it will reduce the tension of the fabric. Buttons with 4 holes can be sew a variety of ways, that may be interesting detail. Here are some great ways to sew a button: button sewing crosswise several times to stretch the thread through the two opposite holes in the button. Sewing parallel, connect the two adjacent holes so that the thread is not interbred. When sewing a square hole is connected alternately in pairs. Bird foot can be done by connecting one hole buttons alternately with the remaining three. Yet you can sew a button "on the leg," which simply must be in very thick fabric, which is made out of clothes. For between the upper (outer) part of the buttons and thread can be make a match or a pin. Once the button is sewn to finish our leg, but must not cut off the thread wrap the leg she had received over the entire length and securely attach it as usual – from the inside our product. With Pipe wrap legs is carefully and do everything slowly, otherwise it will not look presentable. Button with an eye sewn without feet, securely fastened to the fabric. A small needle can sew with inside out, sell it neatly between the threads of the material.